1

E30 Load Resistor Installation Guide

Bryon

Last Update 3 years ago

Vehicles Without Check Relay


No Resistors Needed for vehicles without check relay. If you are trying to eliminate "hyper-flash" see our flasher relay options.


Vehicles with Check Relay (Requires 4 sets)


Low Beams

(Driver Side) Install in parallel by connecting one lead of the resistor to the Yellow/White wire of the headlight plug and the the other end of the resistor to the Brown wire of the headlight plug. Mount to the body of the car away from anything sensitive to heat and/or flammable.


(Passenger Side) Install in parallel by connecting one lead of the resistor to the Yellow/Blue wire of the headlight plug and the the other end of the resistor to the Brown wire of the headlight plug. Mount to the body of the car away from anything sensitive to heat and/or flammable.



Stop Lights

(Driver Side) Install in parallel by connecting one lead of the resistor to the Green/Yellow wire of the main incoming harness in the trunk and the the other end of the resistor to the Brown wire of the main trunk harness. Mount to the body of the car away from anything sensitive to heat and/or flammable.


(Passenger Side) Install in parallel by connecting one lead of the resistor to the Green/Blue wire of the main incoming harness in the trunk and the the other end of the resistor to the Brown wire of the main trunk harness. Mount to the body of the car away from anything sensitive to heat and/or flammable.



Tail Lights

(Driver Side) Install in parallel by connecting one lead of the resistor to the Gray/Blue wire of the main incoming harness in the trunk and the the other end of the resistor to the Brown wire of the main trunk harness. Mount to the body of the car away from anything sensitive to heat and/or flammable.


(Passenger Side) Install in parallel by connecting one lead of the resistor to the Gray/Green wire of the main incoming harness in the trunk and the the other end of the resistor to the Brown wire of the main trunk harness. Mount to the body of the car away from anything sensitive to heat and/or flammable.



Licence Plate Lights

(Driver Side) Install in parallel by connecting one lead of the resistor to the Gray wire of the main incoming harness in the trunk and the the other end of the resistor to the Brown wire of the main trunk harness. Mount to the body of the car away from anything sensitive to heat and/or flammable.


(Passenger Side) Install in parallel by connecting one lead of the resistor to the Gray/Black wire of the main incoming harness in the trunk and the the other end of the resistor to the Brown wire of the main trunk harness. Mount to the body of the car away from anything sensitive to heat and/or flammable.

Was this article helpful?

0 out of 0 liked this article

Still need help? Message Us